Smartek-systems SVS-1 User Guide-Part B Instrukcja Użytkownika Pobierz pdf (Strona 28)

Scenario 6 Set Output Relays

Select Detector Interface and Route Relays:

1) Click the Detector Interface button to select

the type of detector/controller interface to be

used ( BIU #1 SDLC ).

2) Click the Ph- button to select Phase group

5L. Note that the line zones corresponding to

the selected phase group turn green. All others

are magenta.

3) Click the D button to select the detector

channel ( D7) this phase is routed to in the

SDLC message.

4) Click the Ext= and the Dly= to select the

Detection Extension in seconds and the

Detection Delay in seconds.

5) Click N, Or, And button to select logic for

combining (N=Not Used) Phase Groups into

Detector Channels.

6) To clear the settings for the selected Phase

group or for all Phase groups click the Clear or

the Clear All button.

BIU #1 SDLC Detector/Controller Interface with 3 Phases (Line Zone Groups)

Phase 5L, Detection Delay=0 sec, Detection Extension=0, Route to Detector Channel D7

Phase 2T, Detection Delay=0 sec, Detection Extension=0, Route to Detector Channel D8

Phase 2R, Detection Delay=2 sec, Detection Extension=0, Route to Detector Channel D8

Specifies Routing to Onboard Output Relay

Connector (1, 2, .., 10 0-Disables) for shelf

mount SVS-1

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 44 45

Brak uwag

Smartek-systems SVS-1 User Guide-Part B Instrukcja Użytkownika Strona 28